Kenrik KR-EC2-001,Single Port Ethernet over Coax Bridge

Features | Specifications

Overview

The Kenrik KR-EC2-001 single port bridge offers a cost-saving solution when upgrading from analog to IP cameras.
The KR-E2C-001 allows users to transmit full-duplex 10/100 Ethernet traffic over existing coaxial cables. This saves on the cost of new cable, reduces installation labor costs, and eliminates disruptions at the site.

Each KR-E2C-001 has an Ethernet RJ45 jack and a BNC connector. Simply connect the camera to the Ethernet jack and the BNC connector to the existing coaxial cable. Connect another KR-E2C-001 at the other end of the cable run. A 12VDC power supply can be connected to either KR-E2C-001. No configuration is needed.

Specifications

Network Interface

Ethernet: IEEE 802.3 10/100BASE-TX
  Full/Half Duplex
Connector: RJ45

Coaxial Interface

Connector: BNC
Impedance: 75 ohms or 50 ohms

Other

  
Dimensions

0.91 x 2.13 x 4.0 inches (HxWxL)
23 x 54 x 102 mm (HxWxL)
Environmental

Operating Temperature: -20 C to +50 C
(-4 F to +122 F)
Warranty

Three year
Power

12VDC @ 20mA

 

KR-E2C-001 Quick Links

Download Data Sheet

Download A&E Specifications - Under Construction

Download Drawing (PDF) - Under Construction

Features

  • Transmit standard IEEE 802.3 100BASE-TX traffic over 75 or 50 ohm coaxial cable.
  • Long Distances: 100BASE-TX operation provides minimum of;
    - 984 ft (300 meters) over RG6
    - 492 ft (150 meters) over RG59;
    - greater distances with 10BASE-T operation.
  • Instantaneous transmission. No buffering or delays.
  • 100Mbps Full Duplex line speed up to rated distance (i.e., no throughput degradation as distance increases).
  • Simple installation. No programming or setup.
  • Completely software transparent.